Surf tab prototyping. Speed matters. | MISSION Boat Gear
0

Your Cart is Empty

March 20, 2016 1 min read

Milling of wake shaper solutions
Along the way we invested in an industrial strength CNC milling machine to help us reduce development time. Typical R&D projects like this usually take between 16 and 36 months to complete. By staying focused and leveraging digital prototyping and testing methods we were able to cut that down to 8 months! In addition to milling rough mockups, we also leveraged 3d printing technology. The wave for wakesurfing in the photo's shown in this newsletter were generated by a super tough 3d printed prototype. Special thanks to Matt & Mike at AdvancedTek for hooking us up.

Leave a comment

Comments will be approved before showing up.


Also in MISSION Boat Gear Blog

Beginner’s Guide to Your Local Boat Show
Beginner’s Guide to Your Local Boat Show

January 15, 2020 3 min read

Boat shows are big, busy, and loud. It’s pure chaos/excitement but every boater has different tastes, needs, and wants. We’re not here to tell you how to enjoy the boat show. We’re here to help you avoid some of the mistakes that first-time boat show attendees make.
Read More
MISSION to debut new products at the 2020 Minneapolis Boat Show
MISSION to debut new products at the 2020 Minneapolis Boat Show

January 13, 2020 2 min read

Since launching their DELTA wake shaper, SENTRY boat fender, and REEF water mats, MISSION has been a driving innovative force in the outdoor recreation and lifestyle industry. MISSION is set to launch 16 new products for the upcoming boating season at the 2020 Minneapolis Boat Show.
Read More
How To Dispose of Your Foam Water Mat
How To Dispose of Your Foam Water Mat

December 09, 2019 2 min read

Did you finally get tired of hauling a floppy foam burrito on the back of your boat and decide to upgrade to one of our REEF inflatable water mats? Good choice. Now the question is: how do you dispose of that funky floating burden?
Read More

x